SDM6T Unboxing, Leveling and First Power-On
Unpacking, transport lock removal, machine levelling, air and power connection, and the first homing cycle — the exact procedure we follow during remote commissioning.
CAMDENT
How-to guides
Step-by-step procedures for installation, maintenance and troubleshooting
Daily and Weekly Maintenance Checklist
Ten minutes a day: chamber cleaning, spindle cone care, dust filter check, lubrication points and the weekly accuracy verification coupon.
Spindle Calibration and Runout Check
How to measure spindle runout with the supplied gauge, re-calibrate the tool probe and recognise the early signs of bearing wear.
Loading Tools and Setting Tool Life Counters
Insert burs into the 12-position magazine in the right order, run automatic length measurement and configure tool-life counters per material.
CAM Setup: hyperDENT / MillBox Machine Profile
Import the CAMDENT machine profile, configure blank holders, nesting and strategies, then post-process and send the job over LAN.
Zirconia Milling Parameters and Finishing Tips
Recommended feed, spindle load and step-down for zirconia, plus how to avoid chipping on thin margins and how to set the sintering compensation.
Error Codes E01–E20: What They Mean and How to Fix Them
A field guide to the twenty most common alarms: air pressure loss, tool probe failure, communication timeout and spindle overload.
How to Start a Remote Support Session in 3 Minutes
Connect the machine to the internet, launch the remote-assist module and share the session ID with a CAMDENT engineer for live diagnostics.
Tool Loading — install burs step by step
How to insert burs into the magazine and run the automatic tool-length measurement before the first job.
Bur Change — swap a worn tool safely
How to remove a worn bur and install a replacement without damaging the spindle cone.
Contact Us
Step-by-step procedures for installation, maintenance and troubleshooting