▶
Machine Installation
SDM6T Unboxing, Leveling and First Power-On
Unpacking, transport lock removal, machine levelling, air and power connection, and the first homing cycle — the exact procedure we follow during remote commissioning.
CAMBOT CAMDENT
After-sales & Operation Tutorials
Every procedure your team needs, recorded step by step on the official CAMDENT YouTube channel. Play a video here or open it on YouTube to save it to your own list.
How to get help fastest
- Search this page first — 90% of daily questions are covered by a tutorial.
- Still stuck? Ask the CAMDENT AI assistant in the corner; it will send you the matching video and spare-part code.
- For a live diagnosis, start a remote session and share the ID with our engineer on WhatsApp.
After-sales & Operation Tutorials
▶
Daily Maintenance
Daily and Weekly Maintenance Checklist
Ten minutes a day: chamber cleaning, spindle cone care, dust filter check, lubrication points and the weekly accuracy verification coupon.
▶
Troubleshooting
Spindle Calibration and Runout Check
How to measure spindle runout with the supplied gauge, re-calibrate the tool probe and recognise the early signs of bearing wear.
▶
Daily Maintenance
Loading Tools and Setting Tool Life Counters
Insert burs into the 12-position magazine in the right order, run automatic length measurement and configure tool-life counters per material.
▶
Software Operation
CAM Setup: hyperDENT / MillBox Machine Profile
Import the CAMDENT machine profile, configure blank holders, nesting and strategies, then post-process and send the job over LAN.
▶
Software Operation
Zirconia Milling Parameters and Finishing Tips
Recommended feed, spindle load and step-down for zirconia, plus how to avoid chipping on thin margins and how to set the sintering compensation.
▶
Troubleshooting
Error Codes E01–E20: What They Mean and How to Fix Them
A field guide to the twenty most common alarms: air pressure loss, tool probe failure, communication timeout and spindle overload.
▶
Machine Installation
How to Start a Remote Support Session in 3 Minutes
Connect the machine to the internet, launch the remote-assist module and share the session ID with a CAMDENT engineer for live diagnostics.
Daily Maintenance
Tool Loading — install burs step by step
How to insert burs into the magazine and run the automatic tool-length measurement before the first job.
Daily Maintenance
Bur Change — swap a worn tool safely
How to remove a worn bur and install a replacement without damaging the spindle cone.
Frequently Asked Questions
Check the compressor output (0.6 MPa minimum), drain the water separator and inspect the quick connectors for leaks. The procedure is shown in the troubleshooting tutorial about error codes E01–E20.
Every working day. Remove the bur, wipe the cone with a lint-free cloth and a drop of spindle cleaner, then run a tool-length measurement. Detailed steps are in the daily maintenance video.
Yes. Open the job log, select the interrupted strategy and restart from the last completed depth. Make sure the bur is still intact and re-measure its length.
Send the machine serial number and part photo to angelbao@camdent.cn or ask the AI assistant for the part code. Wear parts are dispatched within 48 hours.
Contact Us
Every procedure your team needs, recorded step by step on the official CAMDENT YouTube channel. Play a video here or open it on YouTube to save it to your own list.